A Comprehensive Guide to Diagnosing and Replacing a Non-Working Borewell Pump

Having trouble with your borewell pump and wondering if you can check or replace it without removing it from the casing? This article will guide you through the process. Whether you need a solution for a non-working pump or anxious about a dried-out well, you can find the information here.

Troubleshooting a Non-Working Borewell Pump

Before jumping straight into removing the pump, it is crucial to ensure that the issue isn't related to the power supply. Check if the power source is functioning properly by using a circuit tester or calling an electrician if necessary. Once the power source is confirmed to be stable, proceed with the following steps.

Removing the Cap and Inspecting the Well

To begin with, locate the cap on top of the casing. This cap is usually secured by a compression seal that needs to be loosened. Use a rubber mallet if needed to carefully remove the cap. Take note of the electrical wires connected to the switch and the power line. You will need to disconnect them before proceeding further.

Depending on the depth of the well, you may be able to see if the well has water. If the well is over 100 feet deep, you won't be able to see, smell, or hear the water. At this point, a professional well digger would be needed to clear the well or dig an entirely new one. If the well still has water, it likely means the pump is not working properly.

Removing the Borewell Pump

If the pump needs to be removed, you will need the assistance of two or three people. The pump is connected to the tubing, and it is secured by a poly rope. Loosen the poly rope and use it to pull the pump out of the well. Be cautious and avoid using the tubing as it can slip off the top of the pump. As you pull the rope up, the tubing will start to emerge from the well. Have a helper hold the tubing as it comes out, and if the well is very deep, a third person might be needed to guide the tubing.

Once the pump is removed, you can see the electrical wires connected to the pump. Most likely, these wires will be protected by auto clamps. Loosen the clamps and pull the pump free. At the point where the wires connect to the main cable, you will notice a thicker section, which indicates the waterproof connections. At this stage, you can remove the wires, either for testing or to buy a new pump.

Conclusion

Now that you have identified the problem and removed the pump, you can have it tested or buy a new one to replace it. Replacing a pump isn't an expensive task, but it is one worth doing properly. Invest in a quality pump, as the extra cost is worth it for longevity and reliability. For detailed instructions on reinstallation, consider searching online tutorials. If you find the process challenging, it might be best to seek professional help.